Anritsu ML2430A Manual de usuario descargar pdf (Pagina 126)

FROFF Frequency/Offset Display SYSTEM

Syntax:

FROFF <state>

state:

ON or OFF

Remarks:

This command turns on the top line information text displaying the

frequency and offset for the sensors used, similar to the min-max data

display except the left hand data is for sensor A and the right hand is for

sensor B. This command is only valid if the sensor cal factor source is set

to either frequency or V/GHz, and the sensor is used in a displayed chan

nel.

The display is 'FQ nn.nnGHz OS nnn.nnn' for each sensor.

The frequency (FQ) is the entered frequency if the cal factor source is set

to frequency, or the calculated frequency if the cal factor source is V/GHz.

The offset (OS) is the fixed offset if set to fixed, or the offset table interpo

lated offset value depending on the frequency if the offset for the sensor is

set to table. If the offset for that sensor is OFF, dashes are displayed in the

OS part of the top line data.

Query:

FROFF?

Returned

String:

FROFF <state>

FRST Factory Reset

SYSTEM

Syntax:

FRST

Remarks:

Resets the ML2430A Series to the factory default configuration (see Ap

pendix A). Unlike the *RST command, the offset tables are cleared and all

external interfaces are reset. Note that any settings in the *ESE and *SRE

registers prior to this command will be reset. The equivalent front panel

key sequence is System|Setup|PRESET|FACTORY.

GMNMX Return the minimum and maximum values

DATA OUTPUT

Syntax:

GMNMX <c>

1 or 2

Remarks:

When min/max tracking is turned on, this command is used to read the val

ues. The format returned is:

<min_value>,<max_value>

ML2430A OM 6-39

GPIB OPERATION ML24XXA NATIVE COMMANDS

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 270 271

Comentarios a estos manuales

Sin comentarios

Anritsu ML2430A Manual de usuario Pagina 126

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Anritsu ML2430A