Anritsu Site Master S332D Guía de usuario descargar pdf (Pagina 87)

Ethernet Connectivity (Option 411) 7-3 Ethernet Configuration on the Site Master

Site Master User Guide PN: 10580-00252 Rev. E 7-3

7-3 Ethernet Configuration on the Site Master

LAN Connection

The RJ-45 connector is used to connect the Site Master to a local area network. Integrated

into this connector are two LEDs. The amber LED shows the status of the Ethernet Link:

Link Up (On) or Link Down (Off). The green LED flashes to show that LAN traffic is present.

The instrument IP address is set by pressing the Shift key, then the System (8) key followed

by the

System Options soft key and the Ethernet Config soft key. The instrument Ethernet

address can be set automatically using DHCP, or manually by entering the desired IP

address, gateway address, and subnet mask.

Dynamic Host Configuration Protocol (DHCP) is an Internet protocol that automates the

process of setting IP addresses for devices that use TCP/IP, and is the most common method

of configuring a device for network use. To determine if a network is set up for DHCP, connect

the MT8222B to the network and select DHCP protocol in the

Ethernet Config menu.

Turn the Site Master off, and then on. If the network is set up for DHCP, the assigned IP

address should be displayed briefly after the power up sequence.

Note

An active Ethernet cable must be connected to the instrument before it is turned

ON in order to enable the Ethernet port for DHCP or for a static IP address.

Depending upon local conditions, the port may remain enabled when changing

from DHCP to static IP address, when changing from static IP address to DHCP,

or when temporarily disconnecting the Ethernet cable.

If the port becomes disabled, ensure that an active Ethernet cable is attached to

the instrument before cycling the power OFF and back ON.

Coral-i Solutions

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 111 112

Sin comentarios

Anritsu Site Master S332D Guía de usuario Pagina 87